574-277-0499

FIELD CAN FITTINGS   $9.95 Pictured are the fittings necessary to set up your field cans (gas or smoke). Just add a metal gas can and a small tire foot pump, and you're ready to fill your tanks.

G-23 STANDOFF MOUNT    $19.95
(FOR EARLY MODEL POINTS IGN.)

These 1/2" stand-off mounts will give you adequate clearance (flywheel nut, coil) to mount the G-23 to a flat firewall. They come with 4 Blind Nuts, 4 Standoffs, and 4 Stainless Steel Bolts. They make mounting the G-23 a breeze.

MOUNT STANDOFFS $19.95

These mount stand-offs will give you that extra length to put your engine where you want it. They come in two lengths. Specify: 1/2" or 1 1/8". They will work with most mounts.

"T" HEX KEY WRENCHES

3" SET $6.95 6" SET $7.95
($1.75 ea.) ($2.25 ea.)

We carry "T" wrenches in 2 lengths and 3 popular sizes: 7/64" (#6 screw), 9/64" (#8 screw), and 5/32" (#10 screw) hex. They are made of high quality chrome nickel alloy steel, precision drawn for close tolerance and accuracy, then hardened tempered. The hex size is stamped on the handle for easy identification. Available in package of three or single wrench.

SHIELDED SERVO WIRE      .75 per ft. The shielded wire will give you that extra protection for your long leads. Just solder bare ground wire to negative pin on connector (receiver end only). It's that simple.

G-45 Cylinder Head Wrench $8.95 This special wrench will allow you to remove the G-45 cylinder head with ease. Good to have in the workshop.

Carbide Rotary File $12.95 This carbide rotary file is made to fit your Dremel tool and will allow you to cut & trim spinners (metal & plastic), bolts that are too long, wood firewalls, etc. This is a must for your workshop.

Petroleum Base, low carbon, ashless, 2-cycle oil.   8 oz. can (will mix 2 gal. gas, 32:1)

 Due to constant product improvements, B & B Specialties reserves the right to make changes, including (but not limited to) prices, specifications and accessories without further notice or obligation.